Hayward OmniLogic Installation Manual - Page 24

Raypak RP2100 Pool/Spa Heater, STA-RITE Heater

Get Hayward OmniLogic PDF manuals and user guides View all Hayward OmniLogic manuals
Add to My Manuals
Save this manual to your list of manuals

Page 24 highlights

Raypak RP2100 Pool/Spa Heater 1. Turn power off to heater. 2. Push the mode button to "spa" mode. 3. Set the temperature to the maximum. 4. Push the mode button to "OFF". 5. Lastly, plug the prewired connector in the P7 position on the board. IMPORTANT: The heater will display "OFF" when it is being remotely controlled by the OmniLogic. Some homeowners see the "OFF" display and, thinking this is a mistake, change the mode to "POOL" or "SPA" which then disables the remote control by the OmniLogic. To prevent this: Remove the heater touch pad connector (P5) which will disable the touchpad. STA-RITE Heater 1. Turn power off to heater. 2. Remove upper jacket and open the control box. 3. Remove the jumper for the "fireman's switch. 4. Wire to the OmniLogic using wire rated for 105°C minimum. 20 USE ONLY HAYWARD GENUINE REPLACEMENT PARTS

  • 1
  • 2
  • 3
  • 4
  • 5
  • 6
  • 7
  • 8
  • 9
  • 10
  • 11
  • 12
  • 13
  • 14
  • 15
  • 16
  • 17
  • 18
  • 19
  • 20
  • 21
  • 22
  • 23
  • 24
  • 25
  • 26
  • 27
  • 28
  • 29
  • 30
  • 31
  • 32
  • 33
  • 34
  • 35
  • 36
  • 37
  • 38
  • 39
  • 40
  • 41
  • 42
  • 43
  • 44
USE ONLY HAYWARD GENUINE REPLACEMENT PARTS
20
Raypak RP2100 Pool/Spa Heater
1.
Turn power off to heater.
2.
Push the mode button to “spa” mode.
3.
Set the temperature to the maximum.
4.
Push the mode button to “OFF”.
5.
Lastly, plug the prewired connector in the P7 position on the board.
IMPORTANT:
The heater will display “OFF” when it is being remotely controlled by the OmniLogic.
Some homeowners see the “OFF” display and, thinking this
is a mistake, change the mode to “POOL” or “SPA” which then disables the remote control by the OmniLogic.
To prevent this:
Remove the heater touch pad
connector (P5) which will disable the touchpad.
STA-RITE Heater
1.
Turn power off to heater.
2.
Remove upper jacket and open the control box.
3.
Remove the jumper for the “fireman’s switch.
4.
Wire to the OmniLogic using wire rated for 105°C minimum.