Hayward TracVac TracVac Owners Manual - Page 6
Skimmer Only Connection, Connecting the Hoses
View all Hayward TracVac manuals
Add to My Manuals
Save this manual to your list of manuals |
Page 6 highlights
Skimmer Only Connection If your pool does not have a dedicated suction port, install one section of hose into the skimmer together with the Flow Regulator Valve, as shown. If necessary, use the Hose Cone Adapter to provide a proper seal. NOTE: the Regulator Cap is not used in this installation. 1st Section of Connector Hose Skimmer Flow Regulator Knob Flow Regulator Valve Connecting the Hoses Hose Cone Adapter 1. Attach the Float to the Leader Hose (the single section of hose that will connect to the cleaner). The Float should be placed 20-24" (50cm - 60cm) from the cuff. Do not connect cleaner at this time. Suction End LEADER HOSE Float 20 - 24" Do not connect cleaner at this time 2. From the first section of hose at the suction source, connect together as many hose sections as needed to reach the farthest point of the pool and then add the Leader Hose. Refer to the diagram below and the top of page 6. Hose Connection 5 USE ONLY HAYWARD GENUINE REPLACEMENT PARTS