Hayward TracVac TracVac Owners Manual - Page 7

Leader Hose Suction Source in Center of Pool Leader Hose Suction Source in Corner of Pool Use Flow Gauge to Check Water Flow 1. Submerge the entire length of hose to expunge all air. 2. Insert the Flow Gauge into the end of the Leader Hose. 3. Attach one end of the Double Hose Clip to the Leader Hose and the other end to the first section of hose at the vacuum source. This will form a loop in the pool as shown below. Waterline Hose "Loop" in Pool Double Hose Clip Leader Hose MINIMUM FLOW MAXIMUM FLOW 1st Connector Hose (To Suction) Flow Gauge (Shown between "Min" and "Max" markings) 4. With the air out of the entire hose, verify that the Leader Hose and Flow Gauge are underwater and turn the pump ON. Adjust Flow Regulator Valve knob "faster" or "slower" until the disc indicator in the Flow Gauge settles between "Maximum" and "Minimum" flow. NOTE: If you have an extraordinarily strong pump, you may need to open the main drain slightly. 5. Turn off the pump. Remove the Double Hose Clip and Flow Gauge from the Leader Hose. Submerge the TracVac cleaner to remove all air and then connect the cleaner to the Leader Hose. Cleaner installation is now complete. 6 USE ONLY HAYWARD GENUINE REPLACEMENT PARTS