Hayward W3AQ-TROL-RJ AquaTrol-Above-Ground-Chlorine-Generator-Owners-Manual-09 - Page 2

Important Safety Instructions

Get Hayward W3AQ-TROL-RJ PDF manuals and user guides View all Hayward W3AQ-TROL-RJ manuals
Add to My Manuals
Save this manual to your list of manuals

Page 2 highlights

IMPORTANT SAFETY INSTRUCTIONS When using this electrical equipment, basic safety precautions should always be followed, including the following: • READ AND FOLLOW ALL INSTRUCTIONS • Use Copper Conductors Only • Disconnect all AC power during installation. • Warning - To reduce the risk of injury, do not permit children to use this product unless they are closely supervised at all times. • WARNING - Risk of Electric Shock. Connect only to a grounding type receptacle protected by a ground-fault circuit-interrupter (GFCI). Contact a qualified electrician if you cannot verify that the receptacle is protected by a GFCI. • Do not bury cord. Locate cord to minimize abuse from lawn mowers, hedge trimmers, and other equipment. • WARNING - To reduce the risk of electric shock, replace damaged cord immediately. • WARNING - To reduce the risk of electric shock, do not use extension cord to connect unit to electric supply; provide a properly located outlet. • A green colored terminal marked "Earth Ground" is located inside the wiring compartment. To reduce the risk of electric shock, this terminal must be connected to the grounding means provided in the electric sup- ply service panel with a continuous copper wire equivalent in size to the circuit conductors supplying the equipment. • One bonding lug for US models (two for Canadian models) is provided on the external surface. To reduce the risk of electric shock, connect the local common bonding grid in the area of the swimming pool, spa, or hot tub to these terminals with an insulated or bare copper conductor not smaller than 8 AWG US / 6 AWG Canada. • All field installed metal components such as rails, ladders, drains, or other similar hardware within 3 meters of the pool, spa or hot tub shall be bonded to the equipment grounding bus with copper conductors not smaller than 8 AWG US / 6 AWG Canada. • NOTICE TO USERS: This control product is to be used only in accordance with the directions of this label. It is an offense under the Pest Control Products Act to use a control product under unsafe conditions. • SAVE THESE INSTRUCTIONS USE ONLY HAYWARD GENUINE REPLACEMENT PARTS

  • 1
  • 2
  • 3
  • 4
  • 5
  • 6
  • 7
  • 8
  • 9
  • 10
  • 11
  • 12
  • 13
  • 14
  • 15
  • 16
  • 17
  • 18
  • 19
  • 20
USE ONLY HAYWARD GENUINE REPLACEMENT PARTS
IMPORTANT SAFETY INSTRUCTIONS
When using this electrical equipment, basic safety precautions should always be
followed, including the following:
•
READ AND FOLLOW ALL INSTRUCTIONS
•
Use Copper Conductors Only
•
Disconnect all AC power during installation.
•
Warning - To reduce the risk of injury, do not permit children to use this
product unless they are closely supervised at all times.
•
WARNING - Risk of Electric Shock.
Connect only to a grounding type
receptacle protected by a ground-fault circuit-interrupter (GFCI).
Contact
a qualified electrician if you cannot verify that the receptacle is protected
by a GFCI.
•
Do not bury cord.
Locate cord to minimize abuse from lawn mowers,
hedge trimmers, and other equipment.
•
WARNING - To reduce the risk of electric shock, replace damaged cord
immediately.
•
WARNING - To reduce the risk of electric shock, do not use extension
cord to connect unit to electric supply; provide a properly located outlet.
•
A green colored terminal marked "Earth Ground" is located inside the
wiring compartment.
To reduce the risk of electric shock, this terminal
must be connected to the grounding means provided in the electric sup-
ply service panel with a continuous copper wire equivalent in size to the
circuit conductors supplying the equipment.
•
One bonding lug for US models (two for Canadian models) is provided
on the external surface.
To reduce the risk of electric shock, connect
the local common bonding grid in the area of the swimming pool, spa,
or hot tub to these terminals with an insulated or bare copper conductor
not smaller than 8 AWG US / 6 AWG Canada.
•
All field installed metal components such as rails, ladders, drains, or
other similar hardware within 3 meters of the pool, spa or hot tub shall
be bonded to the equipment grounding bus with copper conductors not
smaller than 8 AWG US / 6 AWG Canada.
•
NOTICE TO USERS: This control product is to be used only in accordance
with the directions of this label. It is an offense under the Pest Control
Products Act to use a control product under unsafe conditions.
•
SAVE THESE INSTRUCTIONS