Hayward W3H400FDP HCC-2000-Automated-Controller-Owners-Manual-092460RevG - Page 9

Configuration Overview Once desired start up chemistry parameters have been established, you are ready to set the HCC 2000 to automatically maintain pH and sanitizer levels. Please refer to the illustration below for controller unit button designations. Button designations appear in bold type. Power: Controller Unit Power Switch 1: Hidden Button (Located Behind "pH" Text) 2: pH Channel Increase Button 3: pH Channel Decrease Button 4: pH Channel Setpoint Adjustment Button 5: pH Channel Mode Selection Button 6: ORP Channel Increase Button 7: ORP Channel Decrease Button 8: ORP Channel Setpoint Adjustment Button 9: ORP Channel Mode Selection Button Basic Configuration Options Selecting Acid or Base Feed The HCC 2000 is preset from the factory to operate in the acid feed mode (when pH exceeds the setpoint, the pH chemical feeder is activated). If the sanitizer used at your facility causes the pH to decrease you must select base feed mode. To switch the controller between acid feed and base feed modes, perform the following steps. Press and hold the Hidden Button (#1) for five seconds to enter advanced setup mode. Scroll to pFD and press the enter key. Scroll to select A for acid feed or B for base feed. Press the Enter key to set your selection, then press the Hidden Button (#1) again to return to normal operating mode. As the unit powers on, the digital pH readout will display an "A" or "B" indicating whether acid feed or base feed mode has been activated. 8 USE ONLY HAYWARD GENUINE REPLACEMENT PARTS