HealthRider H20x Bike Enc Manual - Page 11

See drawing A., See drawing B., See drawing C., Avoid pinching, the cable, start both Screws,

Page 11 highlights

10. Connect the Resistance Cable (37) to the Lower Resistance Cable (34) in the following way: 10 See drawing A. Pull upward on the metal A bracket (A) on the Lower Resistance Cable (34), and insert the tip of the Resistance Cable (37) into the wire clip inside the metal bracket. A See drawing B. Firmly pull the Resistance Cable (37) upward and slide it into the top of the metal bracket (A). 37 34 See drawing C. Using pliers, squeeze the B prongs on the upper end of the metal bracket (A) together. Then, attach the Resistance Control (37) to the Upright (35) with an M5 x 14mm Screw (38). A 37 C A Avoid pinching the cable 34 37 38 35 11. Attach the Water Bottle Holder (21) to the Upright (35) with two M5 x 20mm Screws (27); 11 start both Screws, and then tighten them. 35 21 27 11

  • 1
  • 2
  • 3
  • 4
  • 5
  • 6
  • 7
  • 8
  • 9
  • 10
  • 11
  • 12
  • 13
  • 14
  • 15
  • 16
  • 17
  • 18
  • 19
  • 20
  • 21
  • 22
  • 23
  • 24

11
10
10. Connect the Resistance Cable (37) to the Lower
Resistance Cable (34) in the following way:
See drawing A.
Pull upward on the metal
bracket (A) on the Lower Resistance Cable (34),
and insert the tip of the Resistance Cable (37)
into the wire clip inside the metal bracket.
See drawing B.
Firmly pull the Resistance
Cable (37) upward and slide it into the top of the
metal bracket (A).
See drawing C.
Using pliers, squeeze the
prongs on the upper end of the metal bracket (A)
together.
Then, attach the Resistance Control (37) to the
Upright (35) with an M5 x 14mm Screw (38).
A
B
C
34
37
37
A
A
A
Avoid pinching
the cable
35
34
38
37
11
11. Attach the Water Bottle Holder (21) to the
Upright (35) with two M5 x 20mm Screws (27);
start both Screws, and then tighten them.
21
27
35