HealthRider H20x Bike Enc Manual - Page 12

IMPORTANT: If the Console has, The M5 x 10mm Screws

Page 12 highlights

12. The Console (1) can use two AA batteries (not included); alkaline batteries are recommended. 12 Do not use old and new batteries together or alkaline, standard, and rechargeable batter- ies together. IMPORTANT: If the Console has been exposed to cold temperatures, allow it to warm to room temperature before insert- ing batteries. Otherwise, you may damage the console displays or other electronic components. Remove the battery cover from the back of the Console (1), and insert batteries into the battery compartment; make sure to orient the batteries as shown by the diagram inside the battery compartment. Then, reattach the battery cover. 1 Battery Cover 13. See the inset drawing. The M5 x 10mm Screws (2) may be preattached to the Console (1). 13 36 While a second person holds the Console (1) near the Upright (35), connect the wire on the 1 2 Console to the Upright Wire (36). Tip: Avoid pinching the wires. Attach the Console (1) to the Upright (35) with four M5 x 10mm Screws (2); start all the Screws, and then tighten them. 35 Avoid pinching the wires 1 2 12

  • 1
  • 2
  • 3
  • 4
  • 5
  • 6
  • 7
  • 8
  • 9
  • 10
  • 11
  • 12
  • 13
  • 14
  • 15
  • 16
  • 17
  • 18
  • 19
  • 20
  • 21
  • 22
  • 23
  • 24

12
12
12. The Console (1) can use two AA batteries (not
included); alkaline batteries are recommended.
Do not use old and new batteries together or
alkaline, standard, and rechargeable batter-
ies together.
IMPORTANT: If the Console has
been exposed to cold temperatures, allow it
to warm to room temperature before insert
-
ing batteries. Otherwise, you may damage
the console displays or other electronic
components.
Remove the battery cover from the back of the
Console (1), and insert batteries into the battery
compartment;
make sure to orient the bat
-
teries as shown by the diagram inside the
battery compartment.
Then, reattach the bat-
tery cover.
1
Battery
Cover
13.
See the inset drawing.
The M5 x 10mm Screws
(2) may be preattached to the Console (1).
While a second person holds the Console (1)
near the Upright (35), connect the wire on the
Console to the Upright Wire (36).
Tip: Avoid pinching the wires.
Attach the
Console (1) to the Upright (35) with four
M5 x 10mm Screws (2);
start all the Screws,
and then tighten them.
13
1
1
2
2
35
36
Avoid pinching
the wires