HealthRider Health Rider R1000t Bike Uk Manual - Page 7
Attach the Seat Bracket 7 to the Seat Post 8
View all HealthRider Health Rider R1000t Bike manuals
Add to My Manuals
Save this manual to your list of manuals |
Page 7 highlights
5. Have another person hold the Console (4) near the Handlebar (3). Connect the Upper Wire Harness (42) to the wire harness on the Console (4). Locate the two ground wires that are connected with a screw to the Handlebar (3). Connect the two ground wires to the two smallest wires on the Console. Next, locate the pulse wire extending from the Handlebar. Connect the pulse wire to the remaining wire on the Console. Then, snap the Handlebar Cover (5) onto the Handlebar. Carefully insert all excess wiring into the Console (4). Attach the Console to the metal plate on the Handlebar (3) with four M4 x 16mm Screws (57). Be careful to avoid pinching the wires. 5 4 3 57 6. Turn the Seat Post Knob (20) counterclockwise two or 6 three turns to loosen it. Next, pull the Knob, raise the Seat Post (8) a few inches, and then release the Knob. Move the Seat Post up and down slightly until the pin on the Knob snaps into one of the holes in the Seat Post. Then, turn the Knob clockwise until it is tight. Attach the Seat Bracket (7) to the Seat Post (8) with two M8 x 25mm Patch Screws (59). Make sure that the Seat Bracket is oriented so the slot is on the indicated side. Do not pinch the wires during this step. Ground 5 Wires 42 Pulse Wire 59 7 Slot 8 20 7. Attach the Seat (9) to the Seat Carriage (11) with four 7 M8 Nylon Locknuts (38) and four M8 Split Washers (55). Note: The Nylon Locknuts and Split Washers may be preattached to the underside of the Seat. Slide the Seat Carriage (11) into the Seat Bracket (7). Move the Seat to the desired position. Insert the Seat Knob (10) into the slot in the side of the Seat Bracket, and tighten the Seat Knob into the Seat Carriage. 9 7 11 55 10 38 7