HP 10622 10000 Series Rack Reference Guide - Page 26
Required Tools, Checking the Hardware, Torx screwdrivers-T-10, T-15, and T-30
View all HP 10622 manuals
Add to My Manuals
Save this manual to your list of manuals |
Page 26 highlights
Preparing the Rack for Component Installation Required Tools You need the following tools to install your rack components: • Flat-bladed screwdriver • Phillips screwdrivers-#1, #2, and #3 • Torx screwdrivers-T-10, T-15, T-25, and T-30 • Adjustable wrench • Allen wrench • Cage nut fitting tool (included with original rack hardware kit) For comfort and efficiency while setting up your rack and installing the components, use battery-powered screwdrivers. Checking the Hardware After unpacking the rack and its components, locate the HP Rack Kit Components List that was shipped with your rack. Verify that you received all listed components. You will typically have extra fasteners after completing your rack configuration and component installation. IMPORTANT: Retain the extra fasteners for future use. 3-2 HP 10000 Series Rack Reference Guide