HP 175X HP Jetdirect Print Servers - Administrator Guide - Page 96
Table 3.4, Telnet Commands and Parameters 16 of 18, TCP/IP Configuration 96 - replacement
UPC - 882780301092
View all HP 175X manuals
Add to My Manuals
Save this manual to your list of manuals |
Page 96 highlights
Table 3.4 Telnet Commands and Parameters (16 of 18) DLC/LLC Settings Command Description dlc/llc-config Enables or disables DLC/LLC protocol operation on the print server. 0 disables, 1 (default) enables. For example, dlc/llc-config 0 will disable DLC/LLC operation. strict-8022 Controls DLC/LLC protocol interpretation: 0 (default): disables, that is, provides loose interpretation. 1: enables, that is, provides strict interpretation). Other Settings Command Description link-type (10/100 Fast Ethernet) Sets the print server's link speed (10 or 100 Mbps) and communication mode (Full- or Half-Duplex). Selections are AUTO, 100FULL, 100HALF, 10FULL, 10HALF. For AUTO (default), the print server uses autonegotiation to determine the link speed and mode. If autonegotiation fails, then 100HALF is set. laa Specifies a locally administered address (LAA) that replaces the factory-assigned LAN Hardware (MAC) address. If LAA is used, a user-specified string of exactly 12 hexadecimal digits must be entered. For Token Ring print servers, the LAA address must start with hexadecimal 40 through 7F. For Ethernet print servers, the LAA address must start with hexadecimal X2, X6, XA, or XE, where X is any hexadecimal digit 0 through F. The default address is the factory-assigned address. webscan-config (Web Scan Config) Enables or disables the Web Scan feature on the print server when connected to a supported device. 0 disables, 1 (default) enables. scan-idle-timeout Specifies the number of seconds (1 - 3600) that an idle scan connection is allowed to remain open. 0 disables the timeout. The default is 300 seconds. scan-email-config (Email Scan Config) Enable or disable the scan-to-email feature in the Web Scan server. 0 disables, 1 (default) enables. MFP-config (MFP config) Enable or disable print server support of the client software provided with your multifunction or all-in-one peripheral. 0 (default): disables client software support (allows printing only). 1: enables client software support (allows printing and scanning). ENWW TCP/IP Configuration 96