HP 2300 Service Manual - Page 44

Note CAUTION Transparency specifications Transparency construction is critical. Use only tray 1 to print transparencies. Send transparencies straight through the printer, entering at tray 1 and exiting from the rear output bin. Transparencies that are used in the printer must be able to withstand 200 degrees C (392 degrees F), the printer's fusing temperature. To avoid damaging the printer, use only transparencies that are recommended for use in laser printers. Description Surface resistivity Volume resistivity Finishing precision Fusing compatibility Caliper Specification 2.0 to 15 by 10 to the 10th ohm squared. See "Fusing-compatibility field test" on page 48. 1.2 to 15 by 10 to the 11th ohm-cm. See "Fusing-compatibility field test" on page 48. Cut sheet within 0.79 mm (0.031 inch) of nominal and +0.20 degrees square. Transparency materials must be compatible with the heat and pressure of the fusing process. Materials must not discolor, melt, offset materials, or release hazardous emissions when heated to 200 degrees C (392 degrees F) for 0.1 second. See "Fusing-compatibility field test" on page 48. Caliper of 0.100 to 0.110 mm (0.0039 to 0.0043 inch). See "Caliper field test" on page 46. 42 Installation ENWW