HP 315eu Maintenance and Service Guide - Compaq 100eu Small Form Factor, 100 e - Page 126
Power Button Board
View all HP 315eu manuals
Add to My Manuals
Save this manual to your list of manuals |
Page 126 highlights
Power Button Board Description Power button board Spare part number 624580-001 The power button board is located on the top/left of the computer (viewed from the back). The board is held in place using two tabs. 1. Prepare the computer for disassembly (see Preparing to disassemble the computer on page 106). 2. Remove the stand (see Stand on page 111). 3. Remove the hinge cover (see Hinge Cover on page 112). 4. Remove the memory/optical drive cover (see Memory/Optical Drive Cover on page 107). 5. Remove the outer rear cover (see Rear Cover on page 113). 6. Pull the two tabs that hold the board in place away from the board (1), and then lift the board from the slot (2). 7. Disconnect the cable from the board (3). NOTE: Be careful not to damage the cable when disconnecting it from the board. Do not pull on the wires. Figure 8-10 Removing the power button board To install the power button board, reverse the removal procedures. 116 Chapter 8 Removal and Replacement Procedures All-in One (AIO) Chassis