HP 3600n HP Jetdirect Print Server Administrator's Guide - Page 88

Table 7-5 Error Messages Error Code and Message 02 LAN ERROR - INTERNAL LOOPBACK 03 LAN ERROR - EXTERNAL LOOPBACK 07 LAN ERROR CONTROLLER CHIP 07 AUTHENTICATION FAILED 08 LAN ERROR - INFINITE DEFERRAL Description During self-test, the HP Jetdirect print server detected an internal loopback test error. The print server may be faulty. If the error persists, replace the HP Jetdirect print server. The HP Jetdirect print server is incorrectly connected to your network or is defective. Make sure your HP Jetdirect print server is correctly attached to your network. In addition, check the cabling and connectors. (Wired Ethernet) Check the network connections. If the connections are intact, run the power-on self-test: turn the printer off, then on again. If the error persists, replace the HP Jetdirect print server. The Jetdirect print server could not access the network because of an authentication error. The error depends on the authentication method used. Verify the authentication method and settings on the print server. There is a network congestion problem. NOTE If the print server is not connected to the network, this error cannot occur. 08 AUTHENTICATION IN PROGRESS Link-level authentication is in progress. 09 LAN ERROR - BABBLE Check the network connections. If the connections are intact, run the power-on self-test: turn the printer off, then on again. If the error persists, there may be a problem with the print server. Contact HP support. 0A LAN ERROR - NO SQE (Wired Ethernet) Check the network connections. If the connections are intact, run the power-on self-test: turn the printer off, then on again. If the error persists, there may be a problem with the print server. Contact HP support. 0C LAN ERROR - RECEIVER OFF There may be a problem with your network cabling or the HP Jetdirect print server. Check the cabling and connectors on your Ethernet network. If you cannot find a problem with your network cabling, run the power-on self-test: turn the printer off, then on again. If the error persists after the printer is turned on again, there is a problem with the HP Jetdirect print server. 0D LAN ERROR TRANSMITTER OFF There may be a problem with your network cabling or the HP Jetdirect print server. Check the cabling and connectors on your Ethernet network. If you cannot find a problem with your network cabling, run the power-on self-test: turn the printer off, then on again. If the error persists, there is a problem with the HP Jetdirect print server. 0E LAN ERROR - LOSS OF CARRIER Check the network connections. If the connections are intact, run the power-on self-test: turn the printer off, then on again. If the error persists, there may be a problem with the print server. Contact HP support. 10 LAN ERROR - UNDERFLOW (Wired Ethernet) There may be a problem with your network cabling or the HP Jetdirect print server. Check the cabling and connectors on your network. If you cannot find a problem with your network cabling, run the power-on self-test: turn the printer off, then on again. If the error persists, there is a problem with the HP Jetdirect print server. 11 LAN ERROR - RETRY FAULTS (Wired Ethernet) There is a problem with your network cabling or external network configuration. Verify operation of the hub or switch port. 12 LAN ERROR - NO LINKBEAT With a 10/100 Base-TX port connected, this message is displayed if Link Beat is not sensed. Check the network cable, and verify that the concentrator/hub is providing Link Beat. 13 NETWORK RECONFIG MUST REBOOT Reset or power off/on the HP Jetdirect print server to enable new configuration values. 80 Chapter 7 HP Jetdirect Configuration Page ENWW