HP 60 HP StorageWorks 60 Modular Smart Array Enclosure Maintenance and Service - Page 23

Hot-plug fan

Get HP 60 PDF manuals and user guides View all HP 60 manuals
Add to My Manuals
Save this manual to your list of manuals

Page 23 highlights

Disconnect the power cord from the power supply, and then remove the component as indicated. To replace the component, reverse the removal procedure. Verifying proper operation After replacing the component, check the status LED. Hot-plug fan Verifying component failure Before replacing the component, verify component failure using the following methods: • Check the status LED ("Rear panel LEDs and buttons" on page 35). • Check the host log for errors. CAUTION: To prevent improper cooling and thermal damage, do not operate the storage enclosure unless all bays are populated with either a component or a blank. Removal and replacement procedures 23

  • 1
  • 2
  • 3
  • 4
  • 5
  • 6
  • 7
  • 8
  • 9
  • 10
  • 11
  • 12
  • 13
  • 14
  • 15
  • 16
  • 17
  • 18
  • 19
  • 20
  • 21
  • 22
  • 23
  • 24
  • 25
  • 26
  • 27
  • 28
  • 29
  • 30
  • 31
  • 32
  • 33
  • 34
  • 35
  • 36
  • 37
  • 38
  • 39
  • 40
  • 41
  • 42
Removal and replacement procedures
23
Disconnect the power cord from the power supply, and then remove the component as indicated.
To replace the component, reverse the removal procedure.
Verifying proper operation
After replacing the component, check the status LED.
Hot-plug fan
Verifying component failure
Before replacing the component, verify component failure using the following methods:
•
Check the status LED ("
Rear panel LEDs and buttons
" on page
35
).
•
Check the host log for errors.
CAUTION:
To prevent improper cooling and thermal damage, do not operate the storage enclosure unless
all bays are populated with either a component or a blank.