HP 6120G/XG ProCurve Series 6120 Blade Switches Management and Configuration G - Page 202
Example of Configuring SNTP for Unicast Operation, sntp server
View all HP 6120G/XG manuals
Add to My Manuals
Save this manual to your list of manuals |
Page 202 highlights
Time Protocols SNTP: Viewing, Selecting, and Configuring ProCurve(config)# sntp unicast Activates SNTP in Unicast mode. ProCurve(config)# sntp server 10.28.227.141 Specifies the SNTP server and accepts the current SNTP server version (default: 3). . ProCurve(config)# show sntp SNTP Configuration Time Sync Mode: Sntp SNTP Mode : Unicast Poll Interval (sec) [720] : 720 In this example, the Poll Interval and the Protocol Version appear at their default settings. Both IPv4 and IPv6 addresses are displayed. Note: Protocol Version appears only when there is an IP address configured for an SNTP server. Priority SNTP Server Address 1 2001:db8::215:60ff:fe79:8980 2 10.255.5.24 3 fe80::123%vlan10 OOBM Protocol Version No 7 Yes 3 Yes 3 Figure 9-8. Example of Configuring SNTP for Unicast Operation If the SNTP server you specify uses SNTP version 4 or later, use the sntp server command to specify the correct version number. For example, suppose you learned that SNTP version 4 was in use on the server you specified above (IP address 10.28.227.141). You would use the following commands to delete the server IP address and then re-enter it with the correct version number for that server: Deletes unicast SNTP server entry. Re-enters the unicast server with a nondefault protocol version. show sntp displays the result. Figure 9-9. Example of Specifying the SNTP Protocol Version Number 9-13