HP 635n HP Jetdirect Print Servers - Administrator's Guide - Page 185
Ping in Progress, Link Speed
UPC - 882780301016
View all HP 635n manuals
Add to My Manuals
Save this manual to your list of manuals |
Page 185 highlights
Table C-1 HP Jetdirect EIO Menu on Graphical Control Panel (continued) Menu item Sub-menu item Sub-menu item Values and Description Yes: Print the results. No (default): Do not print the results. Execute Run the ping test. No (default): Do not run the test. Yes: Run the test Ping Results View the ping test status and results, using the control panel display. Packets Sent Number of packets (0 - 65535) sent to the remote host since the most recent test was initiated or completed. Packets Received Number of packets (0 - 65535) received from the remote host since the most recent test was initiated or completed. Percent Lost Percent of sent ping test packets without a response from the remote host since the most recent test was initiated or completed. RTT Min Minimum detected round trip time (RTT), from 0 to 4096 milliseconds, for packet transmission and response. RTT Max Shows the maximum detected round trip time (RTT), from 0 to 4096 milliseconds, for packet transmission and response. RTT Average Average RTT, from 0 to 4096 milliseconds, for packet transmission and response. Ping in Progress Yes a test is in progress. No a test completed or is not running. Refresh Update the ping test data with current results. Yes: Update the data. No: Maintain the existing data. (Automatically refreshes when the menu times out or you manually return to the main menu.) Link Speed Set the print server's link speed. The available settings depend on the device and installed print server. Select one of the following modes: Auto (default): Use auto-negotiation to configure the highest link speed and communication mode allowed. If auto-negotiation fails, either 100TX HALF or 10TX HALF is set depending on the detected link speed of the hub/switch port. (A 1000T half-duplex selection is not supported.) 10T Half: 10 Mbps, half-duplex operation. 10T Full: 10 Mbps, full-duplex operation. 100TX Half: 100 Mbps, half-duplex operation. 100TX Full: 100 Mbps, full-duplex operation. ENWW Graphical control panel menus 175