HP 6910p Intel Centrino 2 with vProâ„¢ technology Setup and C - Page 7

This option is a toggle, the next time it is accessed the opposite setting is prompted. b. DHCP Disable Default Setting : DHCP Enabled Recommended Setting : User Dependent i. Select Y. DHCP can be used if it is available. If DHCP is used, then steps 19c through 19g are not necessary. Otherwise, the system administrator will have to configure TCP/IP settings. For the purpose of this whitepaper, DHCP is disabled so steps 19c through 19g can be illustrated. Step h will appear for both DHCP and Static configurations. c. IP Address i. Enter a static address Default Setting Recommended Setting : 10.0.0.2 : Network Dependent Example: 192.168.0.1 Make sure all AMT systems have a unique static IP address if more than one system is on the same network. Multiple systems sharing the same static IP address can lead to network collisions, which will cause the systems to not respond correctly. d. Subnet Mask i. Enter subnet mask Default Setting Recommended Setting : 255.255.255.0 : Network Dependent Example: 255.255.255.0 e. Default Gateway Address i. Leave as default value and hit Enter Default Setting : 0.0.0.0 Recommended Setting : Network Dependent Leave as 0.0.0.0 if this option is not needed. f. Preferred DNS Address i. Leave as default value and hit Enter Default Setting : 0.0.0.0 Recommended Setting : Network Dependent Leave as 0.0.0.0 if this option is not needed. g. Alternate DNS Address i. Leave as default value and hit Enter Default Setting : 0.0.0.0 Recommended Setting : Network Dependent 7