HP 8/40 Brocade Fabric OS Message Reference guide v6.2.0 (53-1001157-01, April - Page 229
FCR-1059, Message, Probable Cause, Recommended, Action, portDisable, Severity, portCfgShow
View all HP 8/40 manuals
Add to My Manuals
Save this manual to your list of manuals |
Page 229 highlights
27 FCR-1059 FCR-1059 Message , [FCR-1059], ,, INFO, , EX_Port was disabled due to an authentication failure. Probable Cause Indicates that the authentication, which uses the Diffie Hellman - challenge handshake authentication Protocol (DH-CHAP), failed on the EX_Port. Recommended Action Verify that the shared secrets on both sides of the link match. Disable and enable the ports by using the portDisable and the portEnable commands to restart authentication. Severity INFO FCR-1060 Message , [FCR-1060], ,, WARNING, , EX_Port() has an incompatible configuration setting. Probable Cause Indicates that virtual channel (VC) Link Init is enabled on the local switch and the remote switch is negotiating in R_RDY mode. The fabric might not form properly. Recommended Action Check the configuration on the local switch using the portCfgShow command to verify that the VC Link Init is disabled, if the remote switch is configured in R_RDY mode or only capable of R_RDY mode. VC_RDY mode: Virtual-channel flow control mode. This is a proprietary protocol. R_RDY mode: Receiver-ready flow control mode. This is the Fibre Channel standard protocol, that uses R_RDY primitive for flow control. Severity WARNING FCR-1061 Message , [FCR-1061], ,, INFO, , Backbone fabric created on port . Probable Cause Indicates that a backbone fabric was built on the specified port. Recommended No action is required. Action Severity INFO FCR-1062 Message , [FCR-1062], ,, INFO, , Port disabled, system only supports EX/VEX_ports. Fabric OS Message Reference 171 53-1001157-01