HP 8/40 Brocade Fabric OS Message Reference guide v6.2.0 (53-1001157-01, April - Page 454
RCS-1004, Message, Probable Cause, Recommended, Action, haShow, haDisable, haEnable, rcsInfoShow
View all HP 8/40 manuals
Add to My Manuals
Save this manual to your list of manuals |
Page 454 highlights
69 RCS-1004 RCS-1004 Message , [RCS-1004], ,, ERROR, , Application() not registered.() Probable Cause Indicates a specified application did not register with RCS. Recommended Action Run the haShow command to view the HA state. Run the haDisable and the haEnable commands. Run the rcsInfoShow command to view RCS capability on the fabric. RCS is supported in Fabric OS v2.6, v3.1 and greater, and v4.1 and greater. Run the firmwareDownload command to upgrade the firmware for any switches that do not support RCS. Severity ERROR RCS-1005 Message , [RCS-1005], ,, INFO, , Phase , Application returned , 0x. Probable Cause Indicates a receiving switch is rejecting an RCS phase. Recommended Action If the reject is in ACA phase, wait several minutes and then retry the operation from the sender switch. If the reject is in the SFC phase, check if the application license exists for the local domain and if the application data is compatible. Severity INFO RCS-1006 Message , [RCS-1006], ,, INFO, , State , Application AD, RCS CM. Domain returned 0x. Probable Cause Indicates that a remote domain rejected an RCS phase initiated by an application on the local switch. If the reject phase is ACA, the remote domain might be busy and could not process the new request. If the reject phase is SFC, the data sent by the application might not be compatible or the domain does not have the license to support that application. Recommended Action If the reject is in ACA phase, wait several minutes and then retry the operation. If the reject is in the SFC phase, check if the application license exists for the remote domain and if the application data is compatible. 396 Fabric OS Message Reference 53-1001157-01