HP Brocade BladeSystem 4/12 Brocade Network Advisor SAN User Manual v11.1x (53 - Page 394

14 Switch policies • L2 Mode - Select the L2 mode (Access or Trunk).  Access mode allows only one VLAN and allows only untagged frames.  Trunk mode allows more than one VLAN association and allows tagged frames. • Primary - Enter the primary IP address assigned to an L3 port. NOTE Primary and secondary IP fields are applicable only to the external ports and the interface mode must be L3 to enable these fields. • Secondary - Enter the secondary IP address (optional). Multiple (secondary) IP addresses help when the interface and port are part of multiple subnets. 5. Continue to configure the following LAG parameters. These parameters are disabled until you add a DCB port to the LAG members table. • Mode - The ports that are LAG members are in either Static or Dynamic mode. You cannot change the mode on existing members of a LAG. If the mode is set as Dynamic, you can change the dynamic mode type (to Active or Passive) only for newly-added ports, not for existing port members of a LAG. • Type - The type value options are Standard, where the LAG is limited to 16 ports, and Brocade, where the LAG is limited to four ports. The default is Standard. The type is set when you add a LAG; you cannot edit the type using the Edit LAG dialog box. 6. Click OK . The Deploy to LAGs dialog box displays. 7. Click OK after changing the attributes of the current deployment. The Deployment Status dialog box launches. 8. Click Start on the Deployment Status dialog box to save the changes to the selected LAG or LAGs. NOTE If the primary or secondary IP address already exists on another interface, an error message displays in the Status area. 9. Click Close to close the Deployment Status dialog box. 350 Brocade Network Advisor SAN User Manual 53-1002167-01