HP Brocade BladeSystem 4/12 Brocade Network Advisor SAN User Manual v11.1x (53 - Page 754

23 Saving or Copying Allow/Prohibit Matrix configurations to another device FIGURE 329 Save As/Duplicate dialog box 4. Enter a name for the configuration. 5. Enter a description for the configuration. 6. Select the check box for the switch to which you want to save the configuration in the Select Switch table. 7. Click OK. A message displays stating that the outstanding port configuration is discarded when copying a configuration from the switch with more ports to a switch with fewer ports and vice versa. Click OK to close the message. The copied configuration displays in the Available Switches table under the selected switch. To edit this configuration, refer to "Configuring an Allow/Prohibit Matrix" on page 706 or "Configuring an Allow/Prohibit Matrix manually" on page 707. Saving an Allow/Prohibit Matrix configuration to another device NOTE If you receive a 'FICON not supported on switch' error, refer to FICON troubleshooting for a list of possible causes. To save an existing Allow/Prohibit Matrix configuration to another device, complete the following steps. 1. Select Configure > Allow/Prohibit Matrix. The Configure Allow/Prohibit Matrix dialog box displays. 2. Select the Allow/Prohibit Matrix configuration you want to copy. You can do this by expanding the view for the switch under Available Switches and selecting a configuration, or you may select the matrix under Allow/Prohibit Matrix. 3. Click Save As. The Save As/Duplicate dialog box displays. 710 Brocade Network Advisor IP User Manual 53-1002168-01