HP CM4730 HP Color LaserJet CM4730 MFP - User Guide - Page 276
Understand accessory lights for the 3-bin mailbox and stapler/stacker
UPC - 882780899667
View all HP CM4730 manuals
Add to My Manuals
Save this manual to your list of manuals |
Page 276 highlights
Understand accessory lights for the 3-bin mailbox and stapler/stacker Light Solid green Solid amber Blinking amber Off Explanation and solution ● The accessory is receiving power and is ready. ● The stapler is low on staples. Stapler Low On Staples appears on the controlpanel display. Fewer than 20 staples remain in the staple cartridge. Replace the staple cartridge. ● The number of pages in the job exceeds the 30-page limit for stapling. TOO MANY PAGES IN JOB TO STAPLE appears on the MFP control-panel display. For jobs that have more than 30 pages, staple the pages manually. ● The accessory is experiencing a hardware malfunction. 66.X.X OUTPUT DEVICE FAILURE appears on the control-panel display. ● The accessory has a staple jam. Stapler Jam appears on the control-panel display. ● The accessory has a paper jam, or a sheet needs to be removed from the unit, even if the sheet is not jammed. 13.XX.YY JAM IN TOP OUTPUT BIN appears on the control-panel display. ● The bin is full. Stacker Bin Full appears on the control-panel display. ● The stapler is out of staples. Replace Stapler Cartridge appears on the control-panel display. ● The jam-access cover is open. Output paper path open appears on the control-panel display. ● The stapler unit is open. Output paper path open appears on the control-panel display. Make sure the staple-cartridge cover is completely closed. ● The firmware is corrupt. Corrupt Firmware In External Accessory appears on the control-panel display. ● The MFP might be in sleep mode. Press any button on the control panel. ● The accessory is not receiving power. Turn the MFP power off. Check that the accessory is properly seated on and connected to the MFP, without any gaps between the MFP and the accessory. Turn the MFP power on. ● The accessory might have been disconnected and reconnected while the MFP power was on. Reinstall Output Device appears on the control-panel display. Reconnect the cable on the accessory. ● The job might have stalled between the MFP and the accessory. Processing... appears on the control-panel display. Turn the MFP power off and then on. 260 Chapter 16 Problem solving ENWW