HP CP6015x HP Color LaserJet CP6015 Series - User Guide - Page 55
Resets menu, RESETS
UPC - 883585363285
View all HP CP6015x manuals
Add to My Manuals
Save this manual to your list of manuals |
Page 55 highlights
Table 2-1 Embedded Jetdirect and EIO Jetdirect menus (continued) Item Sub-item Values Description PACKETS RECEIVED Shows the number of packets (0 - 65535) received from the remote host since the most recent test was initiated or completed. PERCENT LOST Shows the percent of ping test packets that were sent with no response from the remote host since the most recent test was initiated or completed. RTT MIN Shows the minimum detected roundtrip- time (RTT), from 0 to 4096 milliseconds, for packet transmission and response. RTT MAX Shows the maximum detected roundtrip- time (RTT), from 0 to 4096 milliseconds, for packet transmission and response. RTT AVERAGE Shows the average round-trip-time (RTT), from 0 to 4096 milliseconds, for packet transmission and response. PING IN PROGRESS Shows whether a ping test is in progress. YES indicates a test in progress, and NO indicates that a test completed or was not run. REFRESH When viewing the ping test results, this item updates the ping test data with current results. Select YES to update the data, or NO to maintain the existing data. However, a refresh automatically occurs when the menu times out or you manually return to the main menu. LINK SPEED AUTO 10T HALF: 10 Mbps, halfduplex operation. The link speed and communication mode of the print server must match the network. The available settings depend on the product and installed print server. Select one of the following link configuration settings: 10T FULL: 10 Mbps, fullduplex operation. 100TX HALF: 100 Mbps, half-duplex operation. 100TX FULL: 100 Mbps, full-duplex operation. 100TX AUTO: Limits auto-negotiation to a maximum link speed of 100 Mbps. CAUTION: If you change the link setting, network communications with the print server and network device might be lost. AUTO*: The print server uses auto-negotiation to configure itself with the highest link speed and communication mode allowed. If auto-negotiation fails, either 100TX HALF or 10TX HALF is set depending on the detected link speed of the hub/switch port. (A 1000T half-duplex selection is not supported.) 1000TX FULL: 1000 Mbps, full-duplex operation. PRINT PROTOCOLS Use this item to print a page that lists the configuration of the following protocols: IPX/SPX, Novell NetWare, AppleTalk, DLC/LLC. Resets menu The RESETS menu allows you to reset factory settings, disable and enable sleep mode, and update the product after new supplies are installed. ENWW Configure device menu 41