HP DL320 Upgrading to Microsoft Windows Server 2003 with Service Pack 1 on Pro - Page 10

3. Install ProLiant Support Pack (PSP) for Microsoft Windows Server 2003 Version 7.30A (or later), which is available at http://h18023.www1.hp.com/support/files/server/us/locate/3376.html. The PSP contains numerous files. All files must be present in the same directory as the SETUP.EXE program for the PSP to be installed properly. NOTE: During the PSP installation, the HP ProLiant Network Teaming and Configuration for Windows Server 2003 utility will be installed. Use this utility to reteam your network interface controllers if you were previously using network teaming. 4. If HP Smart Array MultiPath Software Version 1.0 was uninstalled prior to the upgrade, install HP Smart Array MultiPath Software Version 2.0. Then, reconnect the SCSI cable to the redundant HBA. Unattended/scripted install After completing the tasks identified in the prerequisites section, continue the upgrade, as instructed below to perform an unattended/scripted install: 1. Using SETUPMGR.EXE, create a distribution on a remote server (or any server that does not contain the OS being upgraded). The SETUPMGR.EXE program can be found in \support\tools\deploy.cab of the Windows Server 2003 SP1 CD. 2. Choose Completely Unattended Install and proceed through the Setup Wizard until it completes. • Add the following in the [UNATTENDED] section of the UNATTEND.TXT file: [UNATTENDED] NTUpgrade=Yes CAUTION: The UNATTEND.TXT file created must be modified to allow unattended upgrade installs. If you do not put the string specified above into the file, the install will automatically default to a clean install. • If you are using the OEMPreinstall flag with the UNATTEND.TXT file, remove the following: [UNATTENDED] OEMPREINSTALL=YES NOTE: Upgrades may fail if the OEMPREINSTALL=YES option is enabled. 3. Start the unattended upgrade. Copy the UNATTEND.TXT file and UNATTEND.BAT file created in steps 1 and 2 to the server you are planning to upgrade. 10