HP ENVY 13-ah0000 Maintenance and Service Guide - Page 43
Display panel ZIF connector cable, Backlight ZIF connector cable
View all HP ENVY 13-ah0000 manuals
Add to My Manuals
Save this manual to your list of manuals |
Page 43 highlights
4. Remove the bottom cover (see Bottom cover on page 26). 5. Disconnect the battery cable from the system board (see Battery on page 28). When replacing the system board, be sure to remove the fan/heat sink assembly (see Fan/heat sink assembly on page 38) and power connector cable (see Power connector cable on page 41) from the defective system board and install them on the replacement system board. Remove the system board: 1. Disconnect the following connectors from the system board: (1) Fingerprint reader zero insertion force (ZIF) connector cable (2) WLAN antenna cables NOTE: The #1/white WLAN antenna cable connects to the WLAN module "#1/Main" terminal. The #2/ black WLAN antenna cable connects to the WLAN module "#2/Aux" terminal. (3) Webcam ZIF connector cable (4) Adhesive strip supporting the display panel ZIF connector cable (5) Display panel ZIF connector cable (6) Rear speaker cable (7) Backlight ZIF connector cable (8) Keyboard ZIF connector cable (9) TouchPad ZIF connector cable (10) Front speaker cable 2. Remove the three Phillips M2.5×6.7 screws (1) that secure the display hinges to the keyboard/top cover. Component replacement procedures 35