HP ENVY Rove 20-k014ca HP ENVY Rove 20 Mobile All-in-One PC - Maintenance and - Page 56
frame and display assembly., Remove the audio/USB board
View all HP ENVY Rove 20-k014ca manuals
Add to My Manuals
Save this manual to your list of manuals |
Page 56 highlights
Remove the audio/USB board: 1. Release the ZIF connector (1) to which the audio/USB board ribbon cable is attached, and then disconnect the audio/USB board ribbon cable from the system board. 2. Remove the four Phillips PM3.0×6.5 screws (2) that secure the audio/USB board to the middle frame and display assembly. 3. Remove the audio/USB board (3) and ribbon cable. Reverse this procedure to install the audio/USB board. 48 Chapter 4 Removal and replacement procedures
Remove the audio/USB board:
1.
Release the ZIF connector
(1)
to which the audio/USB board ribbon cable is attached, and then
disconnect the audio/USB board ribbon cable from the system board.
2.
Remove the four Phillips PM3.0×6.5 screws
(2)
that secure the audio/USB board to the middle
frame and display assembly.
3.
Remove the audio/USB board
(3)
and ribbon cable.
Reverse this procedure to install the audio/USB board.
48
Chapter 4
Removal and replacement procedures