HP ENVY TouchSmart 15-j119wm HP ENVY 15 Notebook PC and HP ENVY TouchSmart 15 - Page 80
Following the 1 through 8 sequence stamped into the heat sink, loosen the eight Phillips
View all HP ENVY TouchSmart 15-j119wm manuals
Add to My Manuals
Save this manual to your list of manuals |
Page 80 highlights
3. Remove the heat sink (2). NOTE: Due to the adhesive quality of the thermal material located between the heat sink and the system board components, it may be necessary to move the heat sink from side to side to detach it. NOTE: Steps 4 and 5 apply to computer models equipped with an Intel processor and a graphics subsystem with discrete memory. 4. Following the 1 through 8 sequence stamped into the heat sink, loosen the eight Phillips PM2.0×11.0 captive screws (1) that secure the heat sink to the system board. 70 Chapter 6 Removal and replacement procedures for Authorized Service Provider parts
3.
Remove the heat sink
(2)
.
NOTE:
Due to the adhesive quality of the thermal material located between the heat sink and
the system board components, it may be necessary to move the heat sink from side to side to
detach it.
NOTE:
Steps 4 and 5 apply to computer models equipped with an Intel processor and a
graphics subsystem with discrete memory.
4.
Following the 1 through 8 sequence stamped into the heat sink, loosen the eight Phillips
PM2.0×11.0 captive screws
(1)
that secure the heat sink to the system board.
70
Chapter 6
Removal and replacement procedures for Authorized Service Provider parts