HP ENVY TouchSmart 17-j141nr HP ENVY 17 Notebook PC HP ENVY TouchSmart m7 Note - Page 97
TouchPad module
View all HP ENVY TouchSmart 17-j141nr manuals
Add to My Manuals
Save this manual to your list of manuals |
Page 97 highlights
3. Remove the Power button board (2). NOTE: The Power button board's cable is attached to the board. Reverse this procedure to install the Power button board. TouchPad module Description For use only on HP ENVY TouchSmart m7 Notebook PC computer models For use on HP ENVY TouchSmart 17 Notebook PC computer models and computer models equipped with a non-TouchScreen display assembly with Leap Motion capability Spare part number 720230-001 720253-001 Before removing the TouchPad button board, follow these steps: 1. Shut down the computer. If you are unsure whether the computer is off or in Hibernation, turn the computer on, and then shut it down through the operating system. 2. Disconnect all external devices connected to the computer. 3. Disconnect the power from the computer by first unplugging the power cord from the AC outlet and then unplugging the AC adapter from the computer. 4. Remove the battery (see Battery on page 39), 5. Remove the display panel (see Display panel on page 50). 6. Remove the service cover (see Service cover on page 40). 7. Remove the hard drive (see Hard drive on page 41). 8. Remove the RTC battery (see RTC battery (see RTC battery on page 54). Component replacement procedures 87