HP G42-300 Compaq Presario CQ42 Notebook PC and HP G42 Notebook PC - Maintenan - Page 67
Remove the Phillips PM2.5×6.5 screw, from the top cover, disengage the rear edge of the top
View all HP G42-300 manuals
Add to My Manuals
Save this manual to your list of manuals |
Page 67 highlights
9. Release the ZIF connector to which the power button board cable (4) is connector and disconnect the cable from the system board. 10. Remove the Phillips PM2.5×6.5 screw (1) from the top cover, disengage the rear edge of the top cover (2) from the base enclosure, and then remove the cover from the computer (3). Reverse this procedure to install the switch cover. Component replacement procedures 57
9.
Release the ZIF connector to which the power button board cable
(4)
is connector and
disconnect the cable from the system board.
10.
Remove the Phillips PM2.5×6.5 screw
(1)
from the top cover, disengage the rear edge of the top
cover
(2)
from the base enclosure, and then remove the cover from the computer
(3)
.
Reverse this procedure to install the switch cover.
Component replacement procedures
57