HP G42-300 Compaq Presario CQ42 Notebook PC and HP G42 Notebook PC - Maintenan - Page 90
Fan/heat sink assembly
View all HP G42-300 manuals
Add to My Manuals
Save this manual to your list of manuals |
Page 90 highlights
Fan/heat sink assembly Description Spare part number Fan/heat sink assembly for use in models that use Universal Memory Architecture (UMA) graphics 606609-001 subsystem memory (includes thermal material) Fan/heat sink assembly for use in models that use discrete graphics subsystem memory (includes 606610-001 thermal material) Fan/heat sink assembly for use in models that use DSC HD545V graphics subsystem memory (includes thermal material) (for model 1.0 only) 617029-001 NOTE: To properly ventilate the computer, allow at least a 7.6-cm (3-inch) clearance on the right side and rear panel of the computer. The computer uses an electric fan for ventilation. The fan is controlled by a temperature sensor and is designed to turn on automatically when high temperature conditions exist. These conditions are affected by high external temperatures, system power consumption, power management/battery conservation configurations, battery fast charging, and software requirements. Exhaust air is displaced through the ventilation grill located on the left side of the computer. Before removing the fan/heat sink assembly, follow these steps: 1. Shut down the computer. If you are unsure whether the computer is off or in Hibernation, turn the computer on, and then shut it down through the operating system. 2. Disconnect all external devices connected to the computer. 3. Disconnect the power from the computer by first unplugging the power cord from the AC outlet and then unplugging the AC adapter from the computer. 4. Remove the battery (see Battery on page 43). 5. Remove the following components: a. Hard drive (see Hard drive on page 44) b. Optical drive (see Optical drive on page 47) c. Keyboard (see Keyboard on page 53) d. Top cover (see Top cover on page 55) e. Speaker assembly (see Speaker assembly on page 58) f. Display assembly (see Display assembly on page 66) g. System board (see System board on page 73) Remove the fan/heat assembly (fan/heat sink appearance may vary): 1. Turn the system board upside down. 2. Disconnect the fan cable (1) from the system board. 3. Follow the sequence embossed on heat sink to loosen the four Phillips PM2.5×7.0 captive screws (2) that secure the fan/heat sink assembly to the system board. 80 Chapter 4 Removal and replacement procedures