HP Indigo W7200 Writing Head Service Instructions -- CA393-00150Document P/N: - Page 13
Verify focus fine tuning
View all HP Indigo W7200 manuals
Add to My Manuals
Save this manual to your list of manuals |
Page 13 highlights
3. Click Go to Process > Run Color Calibration Wizard. 4. Click Run Wizard. Follow the wizard instructions. NOTE: If necessary see troubleshooting: Color adjust on page 15. Verify focus fine tuning Print the WritingHeadFocus.jlt job and verify focus fine tuning. NOTE: Before continuing, verify that the substrate size is greater or equal to 320 x 460, 115 gm. Figure 2-10 The WritingHeadFocus.jlt printout 1 29.4 area used to identify 3.4 mm banding 2 Used for final linear deskew and leveling Perform the following procedure only if there is no writing head banding (3.4 mm) visible in the 29.4 gray stripe: 1. Click Main Menu > Problem Handling > HP Indigo Print Care > Component Service > Writing Head > Installation of Writing Head with Manual Interface. 2. Click Go to Process > Verify Focus Fine Tuning. 10 Chapter 2 Procedures