HP Indigo WS6000 Preventive Maintenance -- CA393-00660 Rev 08 - Page 12

Check the Digitax fuses AC IN and DC OUT., HP Indigo WS6600 Digital Press, User Guide

Get HP Indigo WS6000 PDF manuals and user guides View all HP Indigo WS6000 manuals
Add to My Manuals
Save this manual to your list of manuals

Page 12 highlights

Component Electrical cabinet ILP WS6600 Type Procedure NOTE: Power down the press ● Vacuum the electrical cabinet. ● Check the Digitax fuses (AC IN and DC OUT). NOTE: Check the fuses with a DVM set to measure resistance. A good fuse will have a reading of 0 Ohm. ● Clean the primer tray. ● Visually check the primer pump hose. CA341-35240 (PIPE 11.4/6.4MM 640MM) ● Perform the monthly and 3 month Corona maintenance according to the HP Indigo WS6600 Digital Press User Guide (CA394-08481). See Appendix D - Corona Maintenance on page 18 ● Clean the pressure roller and lower idler roller. BCS ● Inspect belt for cracks. ● Check that the BCS is properly adjusted. If not, adjust according to Web Handling System (WHS) in the Printing Engine (CA393-00590). 10 Chapter 2 Procedures

  • 1
  • 2
  • 3
  • 4
  • 5
  • 6
  • 7
  • 8
  • 9
  • 10
  • 11
  • 12
  • 13
  • 14
  • 15
  • 16
  • 17
  • 18
  • 19
  • 20
  • 21
  • 22
  • 23
  • 24
  • 25
  • 26
  • 27
  • 28
Component
Procedure
Electrical cabinet
NOTE:
Power down the press
●
Vacuum the electrical cabinet.
●
Check the Digitax fuses (AC IN and DC OUT).
NOTE:
Check the fuses with a DVM set to measure resistance. A good fuse will have a reading of 0 Ohm.
ILP WS6600 Type
●
Clean the primer tray.
●
Visually check the primer pump hose. CA341-35240 (PIPE 11.4/6.4MM 640MM)
●
Perform the monthly and 3 month Corona maintenance according to the
HP Indigo WS6600 Digital Press
User Guide
(CA394-08481). See
Appendix D - Corona Maintenance
on page
18
BCS
●
Clean the pressure roller and lower idler roller.
●
Inspect belt for cracks.
●
Check that the BCS is properly adjusted. If not, adjust according to
Web Handling System (WHS) in the
Printing Engine
(CA393-00590).
10
Chapter 2
Procedures