HP Integrity rx2620 Windows Integrity Management Agents Reference - Page 94
PAL_SET_PROC_FEATURES to escalate future
View all HP Integrity rx2620 manuals
Add to My Manuals
Save this manual to your list of manuals |
Page 94 highlights
8721 8722 8723 8745 8747 8752 8756 8757 8758 8761 8762 8763 8768 8771 8772 8784 8787 8797 8798 8806 8807 Unable to configure the LBA replace I/O backplane Could not scan the card in a populated slot. Typically caused by an improperly installed or faulty PCI card. Reseat or replace the faulty card. Unable to obtain semaphore reset Update to latest recipe System firmware was unable to lock either the global or the micro semaphore. Allow the OLA cell to reboot to BIB, then try the OLA operation again. Or, collect IPMI event logs and contact HP Customer Support for assistance. Probably caused by lots of PDT entries, or no main memory present. Cell was issued an OLA command without first updating the complex profile to reflect its slot as Update the complex profile to include the new configured in the partition. cell. Invalidate NVRAM and reset. Couldn't communicate with OLA cell. Collect IPMI events and contact HP Support. Firmware is taking too long to process requests. The PDH FPGA IPR is not cleared after a MAX_RD_CLR_IPR_TRIES on a cell. Contact HP Support personnel to troubleshoot the problem. PDH FPGA IPR is not cleared after a number of Contact HP Support personnel to troubleshoot PDC attempts. the problem. Core cell data could not be accessed/fabric connections went bad Collect IPMI events and contact HP Support. the specified echelon is not fully populated and is not usable add or replace dimms in the specified echelon An invalid port number has been provided. The port number will be converted to an internal port Contact HP Support personnel to analyze the and processing should continue. fabric. An invalid port number has been provided. The port number will be converted to an internal port Contact HP Support personnel to analyze the and processing should continue. fabric. Many possible causes, repair / replace the appropriate part. Service / replace the appropriate part of, or the entire backplane. Needed information could not be obtained. Reset the MP. FW MCA code uses this PAL_SET_PROC_FEATURES to escalate future MCA to BINIT. This event id when emitted during an MCA processing means that any subsequent global MCA would not cause all the processors in the PD to MCA again. This happens because of the NVRAM is full with unconsumed error logs. Clear the error logs. This shouldn't be occur. But in case it does than clear the error logs of this event type from the nvram. 94 Management Agents Event Tables