HP Integrity rx4640 ATI RADEON 7500 PCI Graphics Controller Installation Guide - Page 9
ATI RADEON 7500 PCI Graphics Controller - operations guide
View all HP Integrity rx4640 manuals
Add to My Manuals
Save this manual to your list of manuals |
Page 9 highlights
Overview ATI RADEON 7500 PCI Graphics Controller Installation Guide Figure 1-1 ATI RADEON 7500 PCI Graphics Controller 1 R 2 DVI S-VIDOUT CRT 27300 4 3 5 MR0494 X ATI RADEON 7500 PCI graphics controller Y DVI-I VGA connector adaptor Z S-Video connector [ DVI-I connector \ Standard 15-pin VGA connector The ATI RADEON 7500 PCI graphics controller has a standard 15-pin VGA connector, a DVI-I connector and an S-Video connector. The S-Video functionality is not supported by either OpenVMS or HP-UX. There is no VGA switch; VGA functions are automatically configured through the console firmware and software. DVI-I to VGA Connector Adaptor OpenVMS does not support direct DVI to DVI operation on the ATI RADEON 7500 card. The DVI port is only useable by using a DVI to analog (VGA) adapter or cable (this part was supplied on the AlphaServer version of the card, but is not supplied for HP Itanium). If a DVI to analog adapter or cable is used, OpenVMS drives both the VGA and DVI interface with the same image. HP-UX does support all video connections, including direct DVI to DVI, DVI to analog (VGA) and VGA to VGA. 2 Chapter 1