HP Jetdirect 695nw HP Jetdirect Print Servers 640n and 695n - Administrator's - Page 67
DLC/LLC, Other
View all HP Jetdirect 695nw manuals
Add to My Manuals
Save this manual to your list of manuals |
Page 67 highlights
Table 3-3 Telnet Commands and Parameters (continued) Status (Read-only parameter.) Current AppleTalk configuration status. READY: HP Jetdirect print server is awaiting data. DISABLED: AppleTalk was manually disabled. DLC/LLC dlc/llc-config INITIALIZING: Print server is registering the node address or name. An additional status message might also be displayed. Use DLC/LLC protocol operation on the print server (if supported). 0: Disable. 1 (default): Enable. strict-8022 NOTE: On HP Jetdirect 640n print servers, all network protocols except TCP/IP are disabled by factory default. Controls DLC/LLC protocol interpretation: 0 (default): Disable. Provide loose interpretation. 1: Enable. Provide strict interpretation. Other upgrade Set the name and location of the firmware upgrade file for the HP Jetdirect print servers. CAUTION: Ensure that command parameters are properly entered and that the upgrade file is a higher version than the currently installed version. The print server attempts to upgrade if the upgrade file contains a higher version than the installed version. The following is the command format: upgrade: The following defines the parameters: IP address of the TFTP server, firmware version of the upgrade file, print server product number path and filename of the firmware upgrade file. laa Specify a locally administered address (LAA) to replace the factory-assigned LAN hardware (MAC) address. If LAA is used, enter a string of exactly 12 hexadecimal digits. For Ethernet print servers, the LAA must start with hexadecimal X2, X6, XA, or XE, where X is any hexadecimal digit 0 through F. The default address is the factory-assigned address. xml-services-conf Allow access by HP Web service applications to XML-based data on the HP Jetdirect print server. 0: Disable. ws-discovery-conf 1 (default): Enable. Allow Microsoft WS discovery protocols on the print server. 1 (default): Enable. 0: Disable. ENWW IPv4 configuration 57