HP Kayak XU 04xx HP Kayak XU Series 04xx, Installing , Connecting & Settin - Page 5
Connecting an External SCSI Accessory, Make sure the SCSI device is terminated correctly-either
![]() |
View all HP Kayak XU 04xx manuals
Add to My Manuals
Save this manual to your list of manuals |
Page 5 highlights
HP Kayak XU PC Workstation - Setting Up and Using Your HP PC Workstation Connecting an External SCSI Accessory Connecting an External SCSI Accessory An external SCSI device can be connected as follows: 1 You should assign an unused SCSI ID to the device. SCSI IDs range from 0 to 15 for wide 16-bit SCSI devices. Generally, the SCSI ID 0 is reserved for the first SCSI hard disk drive and SCSI ID 7 is reserved for the SCSI controller (the default for narrow and wide SCSI devices). NOTE Depending on your operating system, you may need to set a SCSI ID for Plug and Play SCSI devices (SCSI devices that support the SCAM protocol). 2 Make sure the SCSI device is terminated correctly-either internally or by a terminating resistor (refer to the manual provided with the SCSI device). 3 Connect the SCSI device to your PC Workstation's external 16-bit SCSI connector with a shielded SCSI cable. Step 2: Make sure the SCSI device is terminated Step 3: Connect SCSI device to your PC Workstation NOTE 4 Refer to the manual provided with the SCSI device to learn how to install any software that may be necessary to use it. The total length of the external SCSI cables should not exceed 3 meters (approximately 10 feet). English 5
![](/manual_guide/products/hewlettpackard-kayak-xu-04xx-hp-kayak-xu-series-04xx-installing-connecting-setting-guide-73a8013/5.png)