HP Kayak XU 04xx HP Kayak XU Series 04xx, SCSI Administration Guide - Page 10

Configuring the SCSI Bus • Enable Disconnection To optimize SCSI bus performance, Enable Disconnection should be set to Yes. • Initiate Wide Negotiation This option determines whether the SCSI channel attempts 16-bit data transfer instead of 8-bit data transfer. • Send Start Unit Command When set to Yes this option reduces the load on your computer's power supply by allowing the interface to power-up SCSI devices one-at-a-time when you start your computer. This option is not supported by some SCSI devices. Some SCSI devices require a jumper to be changed before they can respond to this command. • BIOS Multiple LUN Support More advanced SCSI devices can have several logical units (LUN). This option determines whether booting a SCSI device that has multiple LUNs is supported. Set this option to Yes if your boot device has multiple LUNs. It is set to no by default. • Include in BIOS Scan This setting, when set to Yes, allows the SCSI device to be controlled by the host adapter with this SCSI ID. When set to No, the adapter does not control the SCSI device. Advanced Configuration It is recommended that these settings are not changed. Options Menu Advanced Configuration Options Plug and Play Scam Support Enabled Extended BIOS Translation for DOS Drives > 1 GByte Enabled Reset SCSI Bus at IC Initialization Enabled Options Listed Below Have NO EFFECT if the BIOS is Disabled Host Adapter BIOS (Configuration Utility Reserves BIOS Space).. Enabled Support Removable Disks Under BIOS as Fixed Disks Boot Only Display F6 Message During BIOS Initialization Enabled BIOS Support for Int13 Extensions Enabled Use the and keys to move between options. Press to display a menu with a selection of values. English 5