HP LH4r HP Netserver LH 3/LH 3r Power Supply Upgrade Kit - Page 11
HP NetServer LH 3r
View all HP LH4r manuals
Add to My Manuals
Save this manual to your list of manuals |
Page 11 highlights
Chapter 1 Introduction HP NetServer LH 3r CAUTION Do not unscrew the LH 3r until you have extended the antitip foot from under the front of the rack. This anti-tip device must be extended to prevent the rack and LH 3r from tipping over, which could damage the LH 3r and injure people. To remove the covers: 1. Turn off the HP NetServer and disconnect all power and telephone cords. 2. Remove the screws securing the latch plate and the bezel hinge to the rack. Do not unscrew the entire hinge or bracket from the chassis; remove only the outer screws, so the hinge and the bracket remain attached to the LH 3r chassis. Pull the LH 3r forward from the rack until the lockout device engages with a click (see Figures 1-2 and 1-3). Latch Plate Bezel Hinge Bezel Figure 1-2. Sliding Out the NetServer From the Rack (NetServer LH 3r) 7