HP LH4r HP Netserver LH 3/LH 3r Power Supply Upgrade Kit - Page 17
Setting the New Power Supply in the Open Bay
View all HP LH4r manuals
Add to My Manuals
Save this manual to your list of manuals |
Page 17 highlights
Chapter 2 Cage and Power Supply Installation 1. Set the new PSM in the open bay (see Figure 2-4). The power supply can go into either side of the cage. Set the new power supply module in either side of the open bay. Figure 2-4. Setting the New Power Supply in the Open Bay 2. Push in the PSM, seat it firmly, and tighten the thumbscrews. 3. The new PSM fills only half the cage. Cover the other half with the filler panel from the Upgrade Kit. Fasten the panel in place with its thumbscrews. The PSM is now installed. However, do not turn on the server until you install the fan module from the Upgrade Kit. See Chapter 3. 13
Chapter 2
Cage and Power Supply Installation
13
1.
Set the new PSM in the open bay (see Figure 2-4). The power supply
can go into either side of the cage.
Set the new power supply
module in either side of the
open bay.
Figure 2-4. Setting the New Power Supply in the Open Bay
2.
Push in the PSM, seat it firmly, and tighten the thumbscrews.
3.
The new PSM fills only half the cage. Cover the other half with the
filler panel from the Upgrade Kit. Fasten the panel in place with its
thumbscrews.
The PSM is now installed. However, do not turn on the server until you install
the fan module from the Upgrade Kit. See Chapter 3.