HP LH4r HP Netserver LX Pro User Guide - Page 17

Installing the Application Files onto the Network, Running the Setup Program on a Client PC

Get HP LH4r - NetServer - 256 MB RAM PDF manuals and user guides View all HP LH4r manuals
Add to My Manuals
Save this manual to your list of manuals

Page 17 highlights

Chapter 2 HP NetServer Information Assistant Installing the Application Files onto the Network To install the HP NetServer Information Assistant onto the network, do the following: 1. Run Windows as you normally would, and display the Program Manager . 2. Insert the HP NetServer Information Assistant CD-ROM into the CD-ROM drive. 3. From Program Manager, select the File menu and choose Run. 4. At the command prompt, type the following: {drive}:\infoasst\setup /a where {drive} is the letter of the CD-ROM drive. 5. Follow the instructions that appear on your screen. Running the Setup Program on a Client PC To run the HP NetServer Information Assistant from a client PC, it is necessary for the client to run the setup program that was installed onto the network hard disk, as follows: 1. Run Windows and display the Program Manager. 2. From Program Manager, select the File menu and choose Run. 3. At he command prompt, type the network location where the HP NetServer Information Assistant files were installed, followed by setup. For example, if Information Assistant was installed on drive "N:\windows\iaclient," you would enter the following: N:\windows\iaclient\setup 4. Follow the instructions that appear on your screen. 11

  • 1
  • 2
  • 3
  • 4
  • 5
  • 6
  • 7
  • 8
  • 9
  • 10
  • 11
  • 12
  • 13
  • 14
  • 15
  • 16
  • 17
  • 18
  • 19
  • 20
  • 21
  • 22
  • 23
  • 24
  • 25
  • 26
  • 27
  • 28
  • 29
  • 30
  • 31
  • 32
  • 33
  • 34
  • 35
  • 36
  • 37
  • 38
  • 39
  • 40
  • 41
  • 42
  • 43
  • 44
  • 45
  • 46
  • 47
  • 48
  • 49
  • 50
  • 51
  • 52
  • 53
  • 54
  • 55
  • 56
  • 57
  • 58
  • 59
  • 60
  • 61
  • 62
  • 63
  • 64
Chapter 2
HP NetServer Information Assistant
11
Installing the Application Files onto the Network
To install the HP NetServer Information Assistant onto the network, do the
following:
1.
Run Windows as you normally would, and display the Program Manager .
2.
Insert the HP NetServer Information Assistant CD-ROM into the CD-ROM
drive.
3.
From Program Manager, select the File menu and choose Run.
4.
At the command prompt, type the following:
{drive}
:\infoasst\setup /a
where
{drive}
is the letter of the CD-ROM drive.
5.
Follow the instructions that appear on your screen.
Running the Setup Program on a Client PC
To run the HP NetServer Information Assistant from a client PC, it is necessary
for the client to run the setup
program that was installed onto the network hard
disk, as follows:
1.
Run Windows and display the Program Manager.
2.
From Program Manager, select the File menu and choose Run.
3.
At he command prompt, type the network location where the HP NetServer
Information Assistant files were installed, followed by
setup
.
For example
, if Information Assistant was installed on drive
“N:\windows\iaclient,” you would enter the following:
N:\windows\iaclient\setup
4.
Follow the instructions that appear on your screen.