HP LH4r HP Netserver LXr 8500 Reference Guide - Page 38

PDU Rack Power Configurations

Get HP LH4r - NetServer - 256 MB RAM PDF manuals and user guides View all HP LH4r manuals
Add to My Manuals
Save this manual to your list of manuals

Page 38 highlights

Chapter 3 Location of Receptacles for Jumper Cables for a Typical Rack Procedure for Connecting and Routing Cables to the LXr 8500 Monitor HP Console Switch Note PDU Vertically Mounted with Receptacles Facing Inward DLT Library Mass Storage Unit (Two Inlets) HP NetServer LXr 8500 Mass Storage Unit (Two Inlets) Figure 3-4. Power Connection Locations on a Typical Rack (Rear View) 208V PDU Rack Power Configurations The 208 VAC PDU power configurations appear as shown below in Table 3-1 and Figure 3-5. Recommended 208 VAC Power Configurations In the United States, if you are using a UPS, then use PDU model E7671A or E7672A. Attach the IEC 320 C-19 end of the E7801A cord to the PDU and attach the L6-20 end of the same cord to the NEMA L6-20 receptacle on the UPS. 34

  • 1
  • 2
  • 3
  • 4
  • 5
  • 6
  • 7
  • 8
  • 9
  • 10
  • 11
  • 12
  • 13
  • 14
  • 15
  • 16
  • 17
  • 18
  • 19
  • 20
  • 21
  • 22
  • 23
  • 24
  • 25
  • 26
  • 27
  • 28
  • 29
  • 30
  • 31
  • 32
  • 33
  • 34
  • 35
  • 36
  • 37
  • 38
  • 39
  • 40
  • 41
  • 42
  • 43
  • 44
  • 45
  • 46
  • 47
  • 48
  • 49
  • 50
  • 51
  • 52
  • 53
  • 54
  • 55
  • 56
  • 57
  • 58
  • 59
Chapter 3
Procedure for Connecting and Routing Cables to the LXr 8500
34
Location of
Receptacles
for Jumper
Cables for
a Typical
Rack
Monitor
Note PDU
Vertically
Mounted
with
Receptacles
Facing
Inward
HP Console Switch
DLT Library
Mass Storage Unit
(Two Inlets)
Mass Storage Unit
(Two Inlets)
HP NetServer
LXr 8500
Figure 3-4. Power Connection Locations on a Typical Rack (Rear View)
208V
PDU Rack Power Configurations
The
208 VAC PDU power configurations appear as shown below in Table
3-1
and Figure 3-5.
Recommended 208 VAC Power Configurations
In the United States, if you are using a UPS, then use PDU model E7671A or
E7672A. Attach the IEC 320 C-19 end of the E7801A cord to the
PDU and attach
the L6-20 end of the same cord to the NEMA L6-20 receptacle on the UPS.