HP LH4r HP NetServer LXr Pro8 POST and Beep Codes

HP LH4r - NetServer - 256 MB RAM Manual

Get HP LH4r - NetServer - 256 MB RAM PDF manuals and user guides View all HP LH4r manuals
Add to My Manuals
Save this manual to your list of manuals

HP LH4r manual content summary:

  • HP LH4r | HP NetServer LXr Pro8 POST and Beep Codes - Page 1
    Contents HP NetServer LXrPro8 Error Messages HP NetServer LXrPro8 Beep Codes
  • HP LH4r | HP NetServer LXr Pro8 POST and Beep Codes - Page 2
    HP NetServer LXr Pro8 Error Messages 200 Failure Fixed Disk Since the system does not support IDE drives, this error should never be seen on this system. 210 Stuck Key One of the keys on the keyboard is stuck. This error code will be displayed if the user was pressing one of the keys during system
  • HP LH4r | HP NetServer LXr Pro8 POST and Beep Codes - Page 3
    error may not occur on the HP NetServer LXr Pro8, as the system supports standard VGA with additional higher resolutions. 230 System RAM failed at offset: xxxx This error Setup. If the error persists, the RTC on the system board is faulty. Call your HP service representative for further assistance
  • HP LH4r | HP NetServer LXr Pro8 POST and Beep Codes - Page 4
    . 2. If the problem persists, the RTC on the system board is not working. Call your HP Service Representative for further assistance. (This error will occur when the user flashes a new BIOS into the system, as the CMOS area is cleared by the flash utility. Follow the above instructions to fix CMOS
  • HP LH4r | HP NetServer LXr Pro8 POST and Beep Codes - Page 5
    to the system. Actions You Can Take Enter the SETUP menuby pressing the F2 key during the POST, and fix the system configuration. 2B0h Floppy drive A error This error will be displayed if the floppy drive A failed the POST test. Actions You Can Take 1. Check if power is connected to the floppy
  • HP LH4r | HP NetServer LXr Pro8 POST and Beep Codes - Page 6
    , replace one CPU board at a time and see if the error goes away. Call your HP service representative for further assistance 2B2h Incorrect Drive A type -- run SETUP This error will be displayed if floppy diskette drive A does not fit the drive type specified in the Setup menu. Actions You Can Take
  • HP LH4r | HP NetServer LXr Pro8 POST and Beep Codes - Page 7
    replaced. Call your HP service representative for further assistance. 2F6 Software NMI failed This error will occur if the system tried to generate a software NMI by writing to the register to generate an NMI. Since the HP NetServer LXr Pro8 does not support EISA, this error should not happen. Even
  • HP LH4r | HP NetServer LXr Pro8 POST and Beep Codes - Page 8
    cannot display messages on the monitor when an error occurs before the video display is initialized, generally the BIOS POST error message usually displays on the HP NetServer's message display (located on the control panel). In a few cases, the server emits a series of beeps. The beep codes are
  • 1
  • 2
  • 3
  • 4
  • 5
  • 6
  • 7
  • 8
Contents
HP NetServer LXrPro8 Error Messages
HP NetServer LXrPro8 Beep Codes