HP LH4r HP NetServer LXr Pro8 POST and Beep Codes - Page 3
Actions You Can Take
View all HP LH4r manuals
Add to My Manuals
Save this manual to your list of manuals |
Page 3 highlights
This error should not occur, as the HP NetServer LXr Pro8 has no keyboard lock switch. 220 Monitor type does not match CMOS -- run Setup This error may not occur on the HP NetServer LXr Pro8, as the system supports standard VGA with additional higher resolutions. 230 System RAM failed at offset: xxxx This error will occur if the system RAM test failed during the diagnostic mode memory test. Actions You Can Take: Replace the DIMM that is reported as failed. 231 Shadow RAM failed at offset: xxxx This error will occur if the shadow RAM fails the test. Shadow RAM is a portion of the memory which is used to improve the system performance during access to the option ROMs. Actions You Can Take If the error persists, replace the DIMM that failed. 232 Extended RAM failed at offset: xxxx This error will occur if the RAM test above 1M of memory failed. Actions You Can Take If the error persists, replace the DIMM that failed. 250 System battery is dead -- replace and run Setup If this error is displayed, the system's real time clock chip may not be working correctly. Actions You Can Take 1. Enter the system SETUP menuby pressing the F2 key during POST. 2. Set the system date and time, save the changes, and exit Setup. If the error persists, the RTC on the system board is faulty. Call your HP service representative for further assistance. 251 System CMOS checksum is bad -- Default configuration used If this error is displayed, the system configuration is corrupt and a default configuration has been used.