HP LH4r Ultra3 SCSI Hot-Swap Hard Disk Drive and Tray User Guide
HP LH4r - NetServer - 256 MB RAM Manual
 |
View all HP LH4r manuals
Add to My Manuals
Save this manual to your list of manuals |
HP LH4r manual content summary:
- HP LH4r | Ultra3 SCSI Hot-Swap Hard Disk Drive and Tray User Guide - Page 1
HP NetServer Ultra3 SCSI Hot-Swap Hard Disk Drive and Tray User Guide HP Part Number 5969-5922 Printed in February 2000 - HP LH4r | Ultra3 SCSI Hot-Swap Hard Disk Drive and Tray User Guide - Page 2
-Packard shall not be liable for errors contained herein or for incidental or the use or reliability of its software on equipment that is not furnished guide is for the person who installs, administers, and troubleshoots LAN servers. Hewlett-Packard Company assumes you are qualified in the servicing - HP LH4r | Ultra3 SCSI Hot-Swap Hard Disk Drive and Tray User Guide - Page 3
Procedure 3 Installing the Ultra3 Disk Drive Module 3 Removing the Ultra3 Disk Drive Module 8 Installing the Ultra3 Drive in a Tray (optional 9 3 Supported Configurations 11 4 Warranty and Support 13 Hardware Warranty 13 HP Repair and Telephone Support 13 HP World Wide Web Site 13 - HP LH4r | Ultra3 SCSI Hot-Swap Hard Disk Drive and Tray User Guide - Page 4
- HP LH4r | Ultra3 SCSI Hot-Swap Hard Disk Drive and Tray User Guide - Page 5
cages. The LH3, LH4, and RS-12 cages support a mix-and-match of 1-inch low profile drives and 1.6-inch (4 cm) half-height drives. Other NetServers with six-drive cages support either 1-inch (2.5 cm) low profile drives or 1.6-inch (4 cm) half-height drives. Refer to your NetServer manuals for details - HP LH4r | Ultra3 SCSI Hot-Swap Hard Disk Drive and Tray User Guide - Page 6
a disk spacer.) Verify Contents The Ultra3 SCSI Hot-swap Hard Disk Drive and Tray Accessory Kit contains the following items: • Ultra3 SCSI hot-swap hard disk drive module • disk spacer • Ultra3 SCSI Hot-swap Hard Disk Drive and Tray User Guide If anything is missing or damaged, call your reseller - HP LH4r | Ultra3 SCSI Hot-Swap Hard Disk Drive and Tray User Guide - Page 7
how to install the Ultra3 disk drive module in your HP NetServer, and provides instructions for removing and storing the disk drive module. Additionally, this chapter describes how to attach an Ultra3 drive to a hotswap tray. Installing the Ultra3 Disk Drive Module CAUTION Protect the Ultra3 disk - HP LH4r | Ultra3 SCSI Hot-Swap Hard Disk Drive and Tray User Guide - Page 8
latch and insert your fingers. • Using your fingers, pull the filler panel straight out. Figure 2-1 shows a filler panel being removed from a system with a six-drive hot-swap cage. Your HP NetServer's enclosure may have a four-drive cage or a two-drive cage. Figure 2-1. Removing the Filler Panel 4 - HP LH4r | Ultra3 SCSI Hot-Swap Hard Disk Drive and Tray User Guide - Page 9
Pull the disk spacer forward slightly, to disengage the back two feet and lift. Figure 2-2. Removing the Disk Spacer From a Disk Drive Module To attach a disk spacer to a disk drive module: • Tilt up the front of the disk spacer and engage the back two feet. • Press the disk spacer back, a fraction - HP LH4r | Ultra3 SCSI Hot-Swap Hard Disk Drive and Tray User Guide - Page 10
are inserted horizontally (Figure 2-4); and in other systems, drives are inserted vertically (Figure 2-5). Be careful of the light pipes as you insert the drive. The light pipes are fragile. CAUTION You must insert the drive slowly and gently. The connector is designed with some long pins that - HP LH4r | Ultra3 SCSI Hot-Swap Hard Disk Drive and Tray User Guide - Page 11
Chapter 2 Installation Procedure Figure 2-4. Installing the Disk Drive Module in the Horizontal Position Figure 2-5. Installing the Disk Drive Module in the Vertical Position 7 - HP LH4r | Ultra3 SCSI Hot-Swap Hard Disk Drive and Tray User Guide - Page 12
about 30 seconds for the hard disk drive to stop spinning and the drive heads to park. 4. Use your hand to support the bottom of the disk drive module. Slowly pull the disk drive module straight out. Do not allow the disk drive module to fall. 5. If your disk drive modules are inserted vertically - HP LH4r | Ultra3 SCSI Hot-Swap Hard Disk Drive and Tray User Guide - Page 13
have two different sizes: the 1.6-inch (4 cm) half-height drive uses tray accessory D6127A, and the 1-inch (2.5 cm) low profile drive uses tray accessory D6128A. (These tray accessories also support Ultra2 drives.) CAUTION Handle the drive and tray gently during assembly. Start all screws prior to - HP LH4r | Ultra3 SCSI Hot-Swap Hard Disk Drive and Tray User Guide - Page 14
in place, then tighten snugly. Do not over tighten. 4. Insert the four screws that attach the Ultra3 drive to the hot-swap tray, then tighten snugly. Do not over tighten. 1. Drive fits into tray 2. SCA extender plugs into drive 3. Two screws hold SCA extender in place 4. Four screws attach the - HP LH4r | Ultra3 SCSI Hot-Swap Hard Disk Drive and Tray User Guide - Page 15
3 Supported Configurations Supported configurations can be found in all of the following sources: • The Installation Guide (or User Guide) shipped with your HP NetServer. • The HP NetServer Online Documentation CD-ROM. • The Installation Guide (or User Guide) for your HP NetServer can be viewed and - HP LH4r | Ultra3 SCSI Hot-Swap Hard Disk Drive and Tray User Guide - Page 16
- HP LH4r | Ultra3 SCSI Hot-Swap Hard Disk Drive and Tray User Guide - Page 17
and Service/Support Booklet section of your HP NetServer system documentation for instructions on how to obtain HP repair and telephone support. HP World Wide Web Site Refer to the following World Wide Web (WWW) site for technical specifications on Hewlett-Packard hard disk drives: http://www.hp.com - HP LH4r | Ultra3 SCSI Hot-Swap Hard Disk Drive and Tray User Guide - Page 18
- HP LH4r | Ultra3 SCSI Hot-Swap Hard Disk Drive and Tray User Guide - Page 19
Hard Disk Drives Model Number(s): D6104A, D6106A, D6107A, D6108A, D7031A, D7174A, D7175A, D9419A, D1166A, P1216A, P1217A Product Options: N/A conforms to the following Product Specifications Contact: Local Hewlett-Packard Sales and Service Office or Hewlett-Packard GmbH, Herrenberger Straße 130 - HP LH4r | Ultra3 SCSI Hot-Swap Hard Disk Drive and Tray User Guide - Page 20
- HP LH4r | Ultra3 SCSI Hot-Swap Hard Disk Drive and Tray User Guide - Page 21
specifications, 15 F filler panel, 1 removing, 4 I inserting a disk spacer, 5 inserting the disk drive module, 6 M mounting on tray, 10 R regulatory information, 15 removing a disk spacer, 5 removing a filler panel, 4 removing disk drive module, 8 S Supported Configurations, 11 U Ultra2 drive
-
1 -
2 -
3 -
4 -
5 -
6 -
7 -
8
-
9
-
10
-
11
-
12
-
13
-
14
-
15
-
16
-
17
-
18
-
19
-
20
-
21
 |
 |
HP NetServer
Ultra3 SCSI Hot-Swap
Hard Disk Drive and Tray
User Guide
HP Part Number 5969-5922
Printed in February 2000