HP LH4r Ultra3 SCSI Hot-Swap Hard Disk Drive and Tray User Guide - Page 14

SCA extender, plugs into drive, Two screws hold, SCA extender in place

Get HP LH4r - NetServer - 256 MB RAM PDF manuals and user guides View all HP LH4r manuals
Add to My Manuals
Save this manual to your list of manuals

Page 14 highlights

Chapter 2 Installation Procedure 2. Plug the SCA extender into the Ultra3 drive. 3. Insert the two screws that hold the SCA extender in place, then tighten snugly. Do not over tighten. 4. Insert the four screws that attach the Ultra3 drive to the hot-swap tray, then tighten snugly. Do not over tighten. 1. Drive fits into tray 2. SCA extender plugs into drive 3. Two screws hold SCA extender in place 4. Four screws attach the drive to the tray Figure 2-7. Ultra3 Drive and Tray Installation 10

  • 1
  • 2
  • 3
  • 4
  • 5
  • 6
  • 7
  • 8
  • 9
  • 10
  • 11
  • 12
  • 13
  • 14
  • 15
  • 16
  • 17
  • 18
  • 19
  • 20
  • 21
Chapter 2
Installation Procedure
10
2.
Plug the SCA extender into the Ultra3 drive.
3.
Insert the two screws that hold the SCA extender in place, then tighten
snugly.
Do not over tighten.
4.
Insert the four screws that attach the Ultra3 drive to the hot-swap tray, then
tighten snugly.
Do not over tighten
.
2. SCA extender
plugs into drive
1. Drive fits into tray
3. Two screws hold
SCA extender in place
4. Four screws attach the
drive to the tray
Figure 2-7. Ultra3 Drive and Tray Installation