HP LH4r Ultra3 SCSI Hot-Swap Hard Disk Drive and Tray User Guide - Page 9
To attach a disk spacer to a disk drive module
View all HP LH4r manuals
Add to My Manuals
Save this manual to your list of manuals |
Page 9 highlights
Chapter 2 Installation Procedure 2. Disk spacers attach to the disk drive module with four small feet. To remove a disk spacer from the adjacent disk drive module: • Slide the disk spacer back, a fraction of an inch (2.5 cm), away from your body. • Tilt up the front of the disk spacer to disengage the front two feet. • Pull the disk spacer forward slightly, to disengage the back two feet and lift. Figure 2-2. Removing the Disk Spacer From a Disk Drive Module To attach a disk spacer to a disk drive module: • Tilt up the front of the disk spacer and engage the back two feet. • Press the disk spacer back, a fraction of an inch (2.5 cm), away from your body. • Lower the front of the disk spacer into place to engage the front two feet. 5
Chapter 2
Installation Procedure
5
2.
Disk spacers attach to the disk drive module with four small feet.
To remove a disk spacer from the adjacent disk drive module:
•
Slide the disk spacer back, a fraction of an inch (2.5 cm), away from
your body.
•
Tilt up the front of the disk spacer to disengage the front two feet.
•
Pull the disk spacer forward slightly, to disengage the back two feet and
lift.
Figure 2-2. Removing the Disk Spacer From a Disk Drive Module
To attach a disk spacer to a disk drive module:
•
Tilt up the front of the disk spacer and engage the back two feet.
•
Press the disk spacer back, a fraction of an inch (2.5 cm), away from
your body.
•
Lower the front of the disk spacer into place to engage the front two
feet.