HP LaserJet 9000 HP LaserJet 9000 Series Printer - Getting Started Guide - Page 12

Step 4 Remove internal packaging - roller

Get HP LaserJet 9000 PDF manuals and user guides View all HP LaserJet 9000 manuals
Add to My Manuals
Save this manual to your list of manuals

Page 12 highlights

Step 4 Remove internal packaging Remove all packaging from the printer. WARNING! This printer weighs approximately 63.5 kg (140 lb). HP recommends that four people move it to avoid injury to you and damage to the printer. To remove internal packaging 1 Remove all orange packing material from the exterior of the printer and remove any cardboard or styrofoam material that is not orange. 2 Remove all orange packing material from the standard output bin and the protective film from the display. 3 Open the left-side door and remove the two packing fuser spacers. Orange tape connects fuser spacers to the outside of left door. Remove the orange tape from the fuser shipping locks to the outside of the door. Close the door after removing the fuser spacers and the tape. 4 Open the trays, remove any orange packing material, and close the trays. 5 Open the front door and remove the orange packing tape at the front transfer roller area and on the lock lever for the print cartridge. Close the door. Note Save all packing material. You may need it to repack the printer at a later date. 10 Printer Setup ENWW

  • 1
  • 2
  • 3
  • 4
  • 5
  • 6
  • 7
  • 8
  • 9
  • 10
  • 11
  • 12
  • 13
  • 14
  • 15
  • 16
  • 17
  • 18
  • 19
  • 20
  • 21
  • 22
  • 23
  • 24
  • 25
  • 26
  • 27
  • 28
  • 29
  • 30
  • 31
  • 32
  • 33
  • 34
  • 35
  • 36
  • 37
  • 38
  • 39
  • 40
  • 41
  • 42
  • 43
  • 44
10
Printer Setup
ENWW
Step 4
Remove internal packaging
Remove all packaging from the printer.
WARNING!
This printer weighs approximately 63.5 kg (140 lb). HP recommends
that four people move it to avoid injury to you and damage to the printer.
To remove internal packaging
1
Remove all orange packing material from the exterior of the
printer and remove any cardboard or styrofoam material that is
not orange.
2
Remove all orange packing material from the standard output bin
and the protective film from the display.
3
Open the left-side door and remove the two packing fuser
spacers. Orange tape connects fuser spacers to the outside of
left door. Remove the orange tape from the fuser shipping locks
to the outside of the door. Close the door after removing the fuser
spacers and the tape.
4
Open the trays, remove any orange packing material, and close
the trays.
5
Open the front door and remove the orange packing tape at the
front transfer roller area and on the lock lever for the print
cartridge. Close the door.
Note
Save all packing material. You may need it to repack the printer at a
later date.