HP LaserJet M2727 Service Manual - Page 234

Problem Cause Solution Problems with feeding. The paper has ragged edges. The paper varies from side-to-side. Use high-quality paper that is made for laser printers. Turn the paper over. The paper is too moist, too rough, too heavy or too smooth, has the wrong grain direction, or is of short-grain construction or it is embossed or from a faulty paper lot. Try another kind of paper, between 100 and 250 Sheffield, 4% to 6% moisture content. Open the rear output bin, or use longgrain paper. Print is skewed (crooked). The media guides might be incorrectly adjusted. Remove all media from the input tray, straighten the stack, and then load the media in the input tray again. Adjust the media guides to the width and length of the media that you are using and try printing again. More than one sheet feeds at one time. The media tray might be overloaded. Remove some of the media from the tray. The media might be wrinkled, folded, or Verify that the media is not wrinkled, damaged. folded, or damaged. Try printing on media from a new or different package. The product does not pull media from the The product might be in manual feed media input tray. mode. ● If Manual feed appears on the product control-panel display, press OK to print the job. ● Verify that the product is not in manual feed mode and print your job again. The pickup roller might be dirty or damaged. Replace the pickup roller. See Replace the tray 2 pickup roller on page 40. The paper-length adjustment control in Adjust the paper-length adjustment tray 2 or optional tray 3 is set at a length control to the correct length. that is greater than the media size. 216 Chapter 6 Solve problems ENWW