HP LaserJet M5000 HP LaserJet MFP - Analog Fax Accessory Guide - Page 40
If you are replacing an existing fax accessory, pull up to remove it.
View all HP LaserJet M5000 manuals
Add to My Manuals
Save this manual to your list of manuals |
Page 40 highlights
3. Loosen the two captive thumb screws on the back of the MFP. Figure 1-45 Loosening the screws 4. Grasp the screws and pull the formatter board out of the MFP. Place it on a flat, non-conductive surface. Figure 1-46 Removing the formatter 5. If you are replacing an existing fax accessory, pull up to remove it. Figure 1-47 Replacing an existing fax accessory 32 Chapter 1 Setup ENWW
3.
Loosen the two captive thumb screws on the back of the MFP.
Figure 1-45
Loosening the screws
4.
Grasp the screws and pull the formatter board out of the MFP. Place it on a flat, non-conductive
surface.
Figure 1-46
Removing the formatter
5.
If you are replacing an existing fax accessory, pull up to remove it.
Figure 1-47
Replacing an existing fax accessory
32
Chapter 1
Setup
ENWW