HP Model 745 Model 745 Industrial Controller Owner's Guide - Page 90
tions that may be required for your application.
View all HP Model 745 manuals
Add to My Manuals
Save this manual to your list of manuals |
Page 90 highlights
EISA Card Installation Hardware Installation 5 Note that the slots are numbered from 1 to 4. Loosen the torx screw (see Figure 5-2) for the appropriate slot, and then remove the blank slot plate. Slots 1 2 3 4 Figure 5-2 Figure 5-3 Blank Slot Plate and Screw Installing the EISA card and screw 6 Refer to your EISA card installation manual, and then set any configura- tions that may be required for your application. 7 Install the EISA card in the slot. Make sure its connector is well seated in the EISA backplane. See Figure 5-3. 5-6
5-6
EISA Card Installation
Hardware Installation
5
Note that the slots are numbered from 1 to 4.
Loosen the torx screw (see Figure 5-2) for the appropriate slot, and then
remove the blank slot plate.
Figure 5-2
Blank Slot Plate and Screw
Figure 5-3
Installing the EISA card and screw
6
Refer to your EISA card installation manual, and then set any configura-
tions that may be required for your application.
7
Install the EISA card in the slot. Make sure its connector is well seated in
the EISA backplane. See Figure 5-3.
Slots
1
2
3
4